Not constraining to 91 degrees & 136 degrees instead of 90 degrees & 135 degrees with shift
Even with constrain angle at 0 degrees & smart guides at 45 & 90 degree angles & turning all snapping options off:
holding down shift when rotating while drawing with line segment tool shows live angle snapping at 0, 45, then 91 & 136, then back to 180, 225, 270, 315, then 0 again.
When I release at what it says to be 91 or 136 degrees by my mouse -> I check the rotate properties in the right panel & the angles are correct at 90 & 135 degrees where they snapped.
So it's just displaying the wrong snapping angle hovering over the mouse.
Please fix this.
-
Screenshot%202025-06-08%20at%2020.25.40.png 821 KB -
Screenshot%202025-06-08%20at%2020.25.55.png 760 KB -
Screenshot%202025-06-08%20at%2020.25.16.png 787 KB -
Screenshot%202025-06-08%20at%2020.26.56.png 805 KB -
Screenshot%202025-06-08%20at%2020.26.52.png 758 KB -
Screenshot%202025-06-08%20at%2020.26.15.png 758 KB -
Screenshot%202025-06-08%20at%2020.25.36.png 759 KB -
Screenshot%202025-06-08%20at%2020.26.28.png 758 KB -
Screenshot%202025-06-08%20at%2020.26.36.png 756 KB -
Screenshot%202025-06-08%20at%2020.25.07.png 762 KB
Sunny Yoon
shared this idea
-
Still happens with longer lines when tried in 2 other documents.
But discovered it only displays the wrong figure of 91 & 136 degrees only while holding shift & dragging but after creating the line:
the angle is 90 & 135 degrees correctly on the right properties panel
but the UI also changes to 90 & 135 degrees correctly when you click & hover over the anchor points of the line just created.So it's literally just when I'm making/dragging the line with the line segment tool - it's showing wrong figures of 91 & 135 degrees just at those angles even while holding shift... other smart guide angles show fine, 0, 45, 180, 225, 270, 315.
-
Interesting... Can’t make it happen like this. Does it work with large lines too, or only with these small ones you show? In this document only or in any one?
